How about installation pressure test of corrugated compensator?

There are more safety standards in the actual installation process of corrugated compensator. Before installing pressure test, it is necessary to ensure that the model of the whole corrugated compensator node is checked, and according to the rules and pipeline configuration to ensure that their design is in line with the requirements, for those with expansion joints or one. Some other things in the direction of flowing media should be guaranteed to be all in the same state. What should we pay attention to when installing the ripple compensator in practice?

From the existing situation, in the process of installation of corrugated compensator, we must pay attention to the internal situation of the whole product, need to adjust the expansion of the internal, to ensure that their auxiliary components can fully play their role, and to ensure that the expansion joint can be completely removed after deformation.

When Installing Corrugated compensator, after the installation of pipeline, it should be fully applied to the auxiliary positioning of transportation protection, and all the mechanisms and fasteners can be positioned well. More limited devices should be adjusted to the prescribed position according to the relevant requirements, so as to facilitate the environmental conditions will be sufficient. Compensation.

In the actual installation of corrugated compensator, the design requirements must ensure that in addition to a certain deformation, it is strictly prohibited to use some other deformation methods of corrugated compensator to adjust the installation deviation, so as to avoid affecting the normal function of the final expansion, and even to avoid a series of effects on the whole service life.

The active components of the corrugated compensator can not be jammed by some external parts, and in this case, their normal operation must be limited.